The PARIS Forums: PARIS: Main

Home » The PARIS Forums » PARIS: Main » Seen these?

Show: Today's Messages :: Polls :: Message Navigator

Seen these? [message #55590]

Tue, 12 July 2005 11:42

DC
Messages: 722
Registered: July 2005

Senior Member

nk">audioguy_nospam_@shaw.ca> wrote in message
news:42eb93fa$1@linux...
> I vote for ribbon cables... do you have any Cramolin or
> similar cleaner around? Try applying some to a seperate
> ribbon connector (one not bing used for Paris) then work
> that connector over the pins on the card... kind of like an
> applicator. You could even chop an old IDE cable end in half
> to use. This will wet the

Report message to a moderator

Re: Seen these? [message #55596 is a reply to message #55590]

Tue, 12 July 2005 12:33

HeavyD

Messages: 9
Registered: June 2005

Junior Member

> > >
> >>>cable from MEC 3 to Card B and attached the cable from MEC 2 to card C
> >>>figuring that if it was either a card or cable, I could trace the
> >
> > problem.,
> >
> >>>Well, I found that that hooking this MEC #3 (which was previously
> >
> > attached
> >
> >>>Card C) to Card B and attaching Card C to MEC #2 (which was previously
> >>>attached MEC #3) totlly solves the problem.
> >>>Rock solid, no sync problems and absolutely no discernable reason for
> >
> > this
> >
> >>>behaviour. However, I did add an RME multiface to my Cubase SX system
> >>>yesterday and all of these devices are sharing a common clock so I'm
> >>>wondering if, by some cursed digital happenstance, this might have
> >
> > caused
> >
> >>>the problem. I sort of doubt it though because the system was starting
> >
> > to
> >
> >>>act erratic before I hooked up the Multiface to the SX DAW.
> >&

Report message to a moderator

Previous Topic:	Connection cable EDS100 - Control16, Twisted Pair or normal LAL cable??
Next Topic:	AD Converters

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Fri May 08 20:11:13 PDT 2026

Total time taken to generate the page: 0.02915 seconds