The PARIS Forums


Home » The PARIS Forums » PARIS: Classifieds » Paris Gear for Sale
Paris Gear for Sale [message #54095] Sat, 10 March 2007 13:31 Go to next message
blund is currently offline  blund   UNITED STATES
Messages: 3
Registered: March 2007
Junior Member
lt;/BODY></HTML>

------=_NextPart_000_0125_01C79A6E.E075E010--Hey, Deej - I know someone who just might be interested in the
Portaflex... I'll get in touch with him & let you know.
Everything works on it, right?

Neil

"DJ" <www.aarrrrggghhh!!!.com> wrote:
>13 Slot Magma with two cables-$450.00
>
>Colorgraphics Predator Pro AGP 4 x head graphics card-$100.00
>
>2 x Matrox G450 PCI graphics cards-$25.00 each
>
>Matched pair of Rode NT5 small condenser mics in factory case-$250.00 (these

>are "like new"-I bought them from a friend here who was a dealer and I have

>never used them-this is what I paid for them)
>
>2 x Studio Projects C-1-$125.00 each
>
>2 x AKG C-460B CK 61 omni capsule-$350.0
Re: Paris Gear for Sale [message #54096 is a reply to message #54095] Sat, 10 March 2007 14:02 Go to previous messageGo to next message
blund is currently offline  blund   UNITED STATES
Messages: 3
Registered: March 2007
Junior Member
0 each
>
>Pair of Oktava MK012 mics w
Re: Paris Gear for Sale [message #54098 is a reply to message #54095] Mon, 12 March 2007 19:00 Go to previous messageGo to next message
Paul Braun is currently offline  Paul Braun   UNITED STATES
Messages: 391
Registered: September 2005
Senior Member
. They are the Russian mics,

>not the Chinese copies of the Russian mics. They are not a frequency matched

>pair, but they do sound extremely close and I have used them in this manner

>without any audible wierdness. Very nice sounding mics. they will be shipped

>in a nice Cedar box from the Sound room. One of the clips on one of the
mics
>is damaged, but it does not affect it's functionality as far as holding
the
>mic. I will also be throwing in a pair of rubber banded shock mounts that
I
>bought for these. $500.00
>
>2 x M-Audio CO3 unidirectional format converters-$125.00 each (includes

>power supplies)
>
>M-Audio CO2 bidirectional format converter-$50.00 (includes power supply)
>
>1 x Paris MEC (blackface)-$75.00 OB
Re: Paris Gear for Sale [message #54102 is a reply to message #54095] Thu, 22 March 2007 16:04 Go to previous message
Paul Braun is currently offline  Paul Braun   UNITED STATES
Messages: 391
Registered: September 2005
Senior Member
t fine. It's very old and some of the hardware is
sprung, rusty or was just so far gone that I had to throw it away. I have
been thinking of putting another couple hundred buckin into it for a full
restoration. If the buyer wants authenticy, I would buy the following from
fliptops.com

Cart mount-$2.00
Cart mounting knob assembly-$18.00
Tilt back leg-$10.00
About 8' of gasketing for mounting the reconed Alnico and the front grille
(which buzzes if used while tracking-I usually remove it)-$15.00
B-15 Hardware kit-$90.00 (not really necessary, but a couple of the hinges
are sprung and the other hardware is rusty.

Right now I have a heavy duty EV mounted in the cab that I haven't removed
because it sounds so good. I mounted in in there when I sent the original
speaker fro reconing. The the chrome on the amp was cleaned at one time with
steel wool (not by me) and is abraided a bit, but this isn't a super flaw.
The cabinet has some buzzes that are apparent when the amp is cranked (what
old amp doesn't). It could use some tightening up or crosssbracing to
eliminate these. I have also had the original power cord replaced and an XLR
plug installed to connect the head to the cab and the ground switch on the
front of
Previous Topic: Rich Seeger $300 for EDS and 442 including shipping in the US
Next Topic: WTB: Paris 3.0 software (mac)
Goto Forum:
  


Current Time: Mon May 11 05:00:26 PDT 2026

Total time taken to generate the page: 0.04256 seconds